Raspberry Pi of Goemon

Raspberry Pi3 learning blog

「 python 」 一覧

img_20161003_023407

Utilize an internal pull-down resister

In the previous post, I checked how a pull-down resister functioned. When it’s there the system worked as expected. However once it’s taken off, then LED became unstable. Actually, Raspberry Pi 3 contains an internal pull-down resister and you can enable it by coding. Today, I’m gonna show you how you can enable an internal resister and how it works. Don’t worry, it’s very simple 🙂

img_20160928_233036

Control LED by tact switch

In a previous post, how to blink LED with Raspberry Pi 3 was introduced (Blink LED on Raspberry Pi 3 ). In this work, I just got an “output” from Raspberry Pi. Today, I will send an “input” to Raspberry Pi by using a tact switch.By sending an input, you can get Raspberry Pi to send an output. With this work, you can turn on/off your LED with a tact switch. Table of contents Tact switch Hardware setup Code Result Reference What you need You may want a nipper to cut the legs of resister if they are long. Name Qty Resistor …

file_004

Blink LED on Raspberry Pi 3

Blink LED is a very first step for beginners. You can learn how to connect each electric component and control it with minimum numbers of components and a small chunk of code. Table of contents GPIO pin layout Hardware setup Code Result Reference The necessary parts and tools are here. The selection of resistor depends on LED’s Vf (forward voltage). You can usually find the value on its specification/catalog. Name Qty Resistor 1 330 Ω Red LED 1 Vf = 2.0 V Breadboard 1 Breadboard jumper wire (male-female) 2 Nippers 1 1. GPIO pin layout GPIO (General Purpose Input/Output)  is an …